User Tools

Site Tools


hab:snag_list_for_electronics

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Last revision Both sides next revision
hab:snag_list_for_electronics [2019/04/27 17:13]
harvy
hab:snag_list_for_electronics [2019/05/05 08:55]
harvy
Line 16: Line 16:
 The LoRa packet is transmitted but there is no RTTY transmission even though it is logged out as transmitting. The LoRa packet is transmitted but there is no RTTY transmission even though it is logged out as transmitting.
  
-  * +  * Check the program you are using. The lastest version of LoRaTracker no longer sends out RTTY via radio and instead does it via audio instead (this is to test the LoRa decoding capabilities of the payload for receiving) 
 +  * There is a dedicated program for RTTY transmission 
 + 
 +**RTTY put it can't be decoded** 
 + 
 +If it sounds like RTTY (you need have experience to know that) but you can't decode the packets 
 + 
 +  * This is due to the fact the settings you are using is incorrect, try changing the baud rate or bit numbers 
 +  * If you find out that the baud rate doesn'​t match up with the board comments then it could be that you have flashed the arduino chip at wrong frequency i.e. 8mhz for a 16mhz chip
  
hab/snag_list_for_electronics.txt · Last modified: 2019/05/05 08:55 by harvy