User Tools

Site Tools


hab:snag_list_for_electronics

This is list of common issues when using the PITS shield with RPi.

RPi

It's transmitting but I can't decode the RTTY

If you are seeing the correct 2 bands but are getting gobbledygook (random symbols) then try these things.

  • Increase the volume output of SDRSharp. Even though it is a virtual audio device it still has volume, so set that high if you can't get anything
  • Set the Receive filter bandwidth to 300 (or auto)

Pico

No RTTY transmission

The LoRa packet is transmitted but there is no RTTY transmission even though it is logged out as transmitting.

  • Check the program you are using. The lastest version of LoRaTracker no longer sends out RTTY via radio and instead does it via audio instead (this is to test the LoRa decoding capabilities of the payload for receiving)
  • There is a dedicated program for RTTY transmission

RTTY but it can't be decoded

If it sounds like RTTY (you need have experience to know that) but you can't decode the packets

  • This is due to the fact the settings you are using is incorrect, try changing the baud rate or bit numbers
  • If you find out that the baud rate doesn't match up with the board comments then it could be that you have flashed the arduino chip at wrong frequency i.e. 8mhz for a 16mhz chip
hab/snag_list_for_electronics.txt · Last modified: 2019/05/05 08:55 by harvy